- The front end has been eliminated and driving has become easier.Lees verder
- Kawasaki Z125 Pro, initially I wanted to raise the STD Handlebar a bit, so I installed this Spacer.Positioning is much easier with STD Handlebar (The STD Handlebar on the Z125 Pro has a very slight fo...Lees verder
- I thought that if I could raise my body more, it would make driving easier. However, the change in posture made it impossible to determine the position of my hips, and even after reviewing the footpeg...Lees verder
- With the Handlebar Up Spacer, the handlebar is 25mm higher and at the same time, it is slightly pulled forward, which makes it a very natural and comfortable position to ride in. This position is very...Lees verder
- I recently replaced the Handlebar with a MORIWAKIRacing Handlebar Kit146, and the Quantity:Pair (for Left and Right) Both of them hit the side cowl hard, and we considered what to do about it.I consid...Lees verder
- I considered replacing the handlebar, but I couldn't find a good one, and the HURRICANE Set Back Holder I was wearing was hexagonal, so I decided to use a Round Type Quantity.:I was worried about whet...Lees verder
- Put it on for a test. It certainly gives you more room in your upper body. However, if I keep the OEMSeat of the Z800, the load on my lower back and hips will increase. Once again, I think OEMPosition...Lees verder
- I used it on my MT-03.It can be installed without any problem.Because I used it in combination with EZ-FIT BAR this time.Throttle Cable is no longer delivered.In this case, it can be processed or long...Lees verder
- Compared to its Ninja 250 sibling, it's not much, but perhaps that's because it's in the Streetfighter category of the NAKED lineup? The handlebar position is a little low.If you are riding 250km to 3...Lees verder
- I bought it because I'm 5'10" tall and my posture is still tight.The feeling is that it is indeed effective. My posture happened a little bit, I guess you could say I'm 1pc. higher in the fist.It's no...Lees verder
- previously owned car Yamaha MT-25 (old model) I've been keeping the parts that I had used for a month at On the WebSite "Compatible with MONKEY125. and the conformity information was updated, so I ins...Lees verder
- Because the Handlebar was somewhat low and cramped feeling, I bought it for a little up.Regarding the installation system, the original Clamp and Up Spacer's SIDE do not become Tsurishi,It looks a...Lees verder
- We are average size of 168 cm, we are concerned about forward tilting posture purchasing. Installation is easy, just put it under Handlebar Post!It is only 25 mm, but it seems like NAKED. (However, Se...Lees verder
- Because the Motorcycle was a bit forward ahead, near the base of the thumb of the palm and the neck hurt during long distance touring,By attaching the Handlebar Up Spacer, it was released from both pa...Lees verder
- Actually I wanted to install Set Back SpacerSince I can not fix it unless I exchange Cable class, I made it to Handlebar Up Spacer.We caught Cable class as NORMAL.Since we slightly upgraded, a system ...Lees verder
- I installed it on z250.The ride posture became Upright, and it became easy to ride by swinging like Off-road motorcycle and MOTARD.There is no discomfort in particular.I have not done a long distance ...Lees verder
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING