Een must-have voor iedereen die moeite heeft met de Z1 / Z2 / KZ1000-serie!
Seat-leer is gesneden voor het maken van Seat-spons voor Slim & Slim, zodat er geen onnodig teveel is en geen stoelpatroon naar beneden wordt verschoven.
Als je eroverheen zit, kun je zien dat het veel smaller is dan de NORMAL. Maakt u zich zorgen over het rijden op een motorfiets als u niet zeker weet waar u staat?
Weg met die dingen en geniet met volle teugen van de Z's !.
Specificeer a.u.b. de verschillende montagehaak voor Z1 (type met enkele staaf) en KZ1000 (U-vorm) ..
1. Probeer de Slim-stoel op de plaats te plaatsen waar u de normale stoel hebt verwijderd.. Als we het daar zonder problemen kunnen krijgen.
2. Bevestig de SeatFitting aan de voor- en achterkant van de framebeugel voor de zijwaartse opening.
Draai nu de pasbouten los en installeer ze tijdelijk.. zo
→ Als het niet goed sluit, of als het omhoog komt, of als het te hard de achterkap raakt, moet u mogelijk de hoogte van de fitting aanpassen.
→ Als de installatie is gelukt, wijzigt u naar 3 ..
3. Installeer het rubberen kussen achter de stoel.. zo
→ Als u een probleem vindt, zoals de stoel is vervormd of opgetild na het zitten, moet u het rubberen kussen aanpassen.
U moet de hoogte aanpassen enzovoort om het gemiddelde te halen.
→ Als het geen probleem is, is dat het !.
Hefinrichting type Z1 / Z2 (type met enkele staaf) (zie foto) en U-vormig type voor KZ1000-serie
It is a necessity for the person who has trouble with the footing in Z1 / Z2 / KZ1000 series.
The seat leather is cut for the molding of the Slim & Slim seat sponge, so there is no unnecessary excess or shifting of the seat pattern downwards.
When you ride on it, you can see that the width is much narrower than stock.If you don't feel comfortable with your feet, you won't feel comfortable riding the bike, will you?
Please solve these problems and enjoy Z to the fullest.
The mounting hitch for Z1 (single bar type) and KZ1000 series (U-shaped) are different, so please specify.
1. Please put the slim seat on the place where the stock seat was removed.If I can get it on without a problem
Install the seat fitting to the front and rear of the frame bracket for horizontal opening.
At this time, loosen the fitting mounting bolts and leave them temporarily installed.therefore
If there is a problem such as it doesn't close properly, it lifts up and closes, or it hits the tail cowl tightly, you need to adjust the height of the fitting.
If the installation is successful, go to step 3.
3. Please install the rubber cushion on the back of the seat.therefore
If the seat is distorted or lifted, the rubber cushion needs to be adjusted.
It is necessary to adjust the height so that it hits on average.
If there is no problem, you are done.