Hoge lichtsterkte LEDX24 st.
[Inhoud van de kit]
1. LED Customizing Board Sequentiële Type Assy
Voor Voor/achter Draaisignalen 2 Draad Type 120 Graadspeld Type 4pcs
2. Tapschroef M3X30 4pcs
3. Kunststof afstandhouder 4st
4. Nylon wasmachine voor het aftappen van 4pcs
*Als de knippercyclus niet compatibel is met het LED-indicatorrelais, zal het niet goed werken. U moet het CF POSH-indicatorrelais afzonderlijk aanschaffen en het indicatorrelais vervangen.
*Er is een geval dat er een specificatiewijziging van de grondstof is door het gemak van de fabrikant. Begrijp alsjeblieft.
■□■ Volgnummer van de indicator specificaties ■□■■ Volgnummer van de indicator specificaties
Gelieve echter te begrijpen dat het basisoordeel over het al dan niet slagen van de inspectie wordt overgelaten aan de inspecteur.
1. Periode 1sec-0,5sec
(Meer dan 60 keer per minuut en minder dan 120 keer per minuut/product knippert 73-75 keer per minuut)
(Openbare kennisgeving met details over de veiligheidsnormen voor wegvoertuigen)
2009.10.24] (Afdeling 2) Is in overeenstemming met artikel 137 (richtingsindicatoren).
2. Bij de productie van knipperlichtbronnen door middel van kettingverlichting moet aan de volgende voorwaarden worden voldaan.
Verlichte apparatuur Test voor motorfietsen, enz. (Overeenkomst Reglement nr. 50)
(1) Elke lichtbron blijft branden tot het einde van de inschakelcyclus nadat hij is ingeschakeld.
(2) De verlichting van de reeks lichtbronnen vindt gelijkmatig en geleidelijk plaats van de binnenste naar de buitenste rand van het zichtbare oppervlak.
(3) Een ononderbroken lijn zonder herhaalde afwisselingen in verticale richting (bv. zonder golven).
(4) De variatie eindigt binnen 200 ms na het begin van de ON cyclus.
High luminosity LED x 24pcs
[Kit Contents]
1. LED customizing board sequential type assy
For front and rear blinkers / 2-wire 120° Pin Type........ 4pcs
2.Tapping screw M3 x 30 4pcs
3. Plastic spacer 4pcs
4. Nylon Washer for Tapping 4pcs
*If the flashing cycle is not compatible with the LED blinker relay, it will not work properly.CF POSH blinker relays must be purchased separately and the blinker relays must be replaced.
*There may be changes in product specifications due to the manufacturer's reasons.
■□■Regarding Sequential blinker specifications■□■
1. cycle 1sec-0.5sec
(More than 60 times per minute and less than 120 times per minute / Product flashes 73-75 times per minute)
2. the following conditions must be met when flashing light sources are produced by chain lighting
(1) Each light source remains lit until the end of the ON cycle after it is turned on.
(2) The lighting of the series of light sources occurs uniformly and progressively from the inner to the outer edge of the apparent surface.
(3) No repetitive alternation in the vertical direction (e.g: A single continuous line (without waves).
(4) The variation ends within 200ms after the start of the ON cycle.