Spigot buitendiameter: 49mm
Spieslengte: 31mm
[Onderdelen die nodig zijn voor de installatie]
Een van de volgende gasklephoudersets
Yoshimura Racing Throttle Holder Set voor TMR Large Body
Yoshimura Racing Throttle Holder Set voor TMR Large Body met Switch (Switch side coupler bedrading nodig)
Isolatie en band (Suzuki originele onderdelen) *Nodig wanneer de luchtreiniger wordt verwijderd..
PIPE,INTAKE/13111-29F00
CLAMP,CARB/09402-58208
[Onderdelen afzonderlijk vereist]
Koelvloeistofreservoir verblijf (761-125-0300)
[Hoe de DUAL STACK werkt]
De DUAL STACK trechter is ontworpen om de prestaties van zowel de korte als de lange trechter plus alfa te leveren.. Elke trechter werkt niet alleen in zijn eigen gebied, maar elke trechter brengt synergetische effecten met zich mee, wat resulteert in een verhoogde verbrandingsefficiëntie en prestaties..
In het geval van een laag openingsbereik
1e trechter:
Naast de gerectificeerde lucht die wordt ingeademd vanuit de 2e trechter, helpt het bij de inname van +α onderdruk.. Hierdoor kan meer lucht worden opgenomen en verbrand dan normaal het geval zou zijn, wat leidt tot een toename van het vermogen bij lage toerentallen..
2e trechter:
Het fungeert als de hoofdtrechter en zuigt gerectificeerde lucht aan..
Op volle kracht
1e trechter:
Als hoofdtrechter zuigt hij snel de benodigde hoeveelheid lucht aan voor de verbranding..
2e trechter:
Door de negatieve druk veroorzaakt door de 1e trechterinlaat wordt de gerectificeerde +α aanzuiglucht geassisteerd.. Hierdoor kan meer lucht worden opgenomen en verbrand dan normaal het geval zou zijn, wat leidt tot een toename van het vermogen op vol gas..
Spigot Outer Diameter :49mm
Spigot Length :31mm
[Parts required for installation]
Either of the following throttle holder sets
・Yoshimura Racing Throttle Holder Set for TMR Large Body
・Yoshimura Racing Throttle Holder Set for TMR Large Body with Switch (Switch side coupler wiring needs to be changed)
Insulator and band (SUZUKI stock parts) *Needed when the air cleaner is removed.
PIPE, INTAKE/13111-29F00
CLAMP, CARB/09402-58208
[Parts required separately]
・Coolant reservoir tank bracket (761-125-0300)
[How the DUAL STACK works]
The DUAL STACK Funnel is designed to provide the performance of both the Short Funnel and the Long Funnel plus alpha.Each funnel does not work only in its own area, but each funnel brings synergistic effect to each other, which leads to the improvement of combustion efficiency, in other words, the improvement of performance.
■In the case of low opening range
・1st funnel:
In addition to the rectified air inhaled from the 2nd funnel, it assists the intake of +α of negative pressure.This allows more air to be drawn in and burned than would normally be the case, leading to an increase in power output at low engine speeds.
・2nd funnel:
It acts as the main funnel and draws in rectified air.
■At full throttle
・1st funnel:
It acts as the main funnel and quickly draws in the necessary amount of air for combustion.
・2nd funnel:
Due to the negative pressure caused by the 1st funnel intake, the rectified +α intake air is assisted.This allows more air to be taken in and burned than would normally be the case, leading to an increase in power output at full throttle.