ODAX POWER BRONZE Naked / Screen
i ordered it directly from ODAX because I don't know when it will be in stock on webikeIt is easy to install. and it takes about 5 minutes to installIt's good that the wind doesn't come directly to yo...
 |  |  |
| | | |
 |  |  |
| | | |
 | ||
| |
ODAX Keiti Fuel Cap Pad
Easy to install (obviously...)Even better if you have a little more fit to the Large size of the tank capI think it's pricey... (it's about $1,500, right?)The older I get, the more I want a Red type
ODAX OBERON Groot staafgewicht
I bought it in July 2019I finally found the Bar End that can be attached to the inner diameter φ12mm of the IMPACTAluminum Handlebar that I had purchased beforehand i finally found the Bar End that ca...
ODAX Keiti Fuel Cap Pad
I ordered it just in case, but it was good.
The quality of the product was good and easy to fit.
I have every intention of buying it again next time.
ODAX RENNTEC Grijprand
I bought it because I sometimes carry a load and do tandem In the picture, I thought it was too large and broke the style, but in reality, I did not feel that uncomfortable It is notIt's easy enough t...
ODAX RENNTEC sportdrager
I had an extra GIVI Top case from a previous Motorcycle that I had used on a previous Motorcycle I bought this Carrier for the purpose of attaching the base plateI haven't put the Plate on yet, so it ...
ODAX EL Meterpaneel
Daylight recognition is better, and Design is goodAt night, the panel is good, but the ZrX1200 DAEG Meter - is a transparent type The numbers are hard to read because the needle is still in theLately ...
ODAX Shinkai Sports Fender Eliminator Kit
Installation was easy and not difficultIs the angle a little too tight? I was satisfied with the quality of the productThe price was a bit high, so I give it a 3
ODAX POWERBRONZE Under Cowl
Installation of the body installation part of each installation Stay without a whole picture It was ManualNo matter how you do it, the Right Side (i.e., the one without an image on the Site) is the on...
ODAX POWER BRONZE Sport / luchtstroom Scherm
I installed it on the H2 SX SE+ The Large size of the mounting hole is not correctI widened the hole to allow the well nut to enterIf this is the case, the inner cover will be distorted by the unreaso...
 |  |  |
| | | |
 |  | |
| | |
 | ||
| |
ODAX IC-knipperrelais
'99 Equipment GSX1300R HAYABUSA Blinker installed to make LED.【Quality / texture】I think that there is no need to worry about texture because it is an invisible place.There are no defects with fun...
ODAX IC-knipperrelais
In blinker LEDization, you do not have to mess with Wiring and do not need any special knowledge.Simply complete with a popping.Especially it can be used without errors in use!
ODAX IC-knipperrelais
When making it LED, when high flasher measures to prevent purchase without using purchase installation, you can remove the Cover and attach it. Although it is using about one year after installation, ...
ODAX IC-knipperrelais
Because I changed the Blinker lens of GSX 1300 R HAYABUSA to SmokeTogether, we introduced this product to try to convert it to LED to increase the stealth property of Valve.Left Side of Relay's ph...
ODAX IC-knipperrelais
I bought it for LEDization of Blinker. I only had to replace the installation with the OEM Product. I had given up thinking about it until then, but I solved it without any problems.
ODAX IC-knipperrelais
Although it was not stated in conformity model, it can be used without problem for BOULEVARDM 109 R. Replaced with front and rear LEDs and blinking boiled away and satisfied ( - ∀ - )
ODAX IC-knipperrelais
Purchased with the introduction of GSX 1300 R HAYABUSA into Blinker LED.Because it is the same shape as OEM, it easily prevents high flasher simply by replacing with OEMRelay.Manufacturer I bought it,...
ODAX IC-knipperrelais
Purchased along with making the GinkX 1400 Blinker an LED.Since it becomes High flasher unless you exchange the Relay, I chose this item as a countermeasure against High flasher.If you are familiar wi...
ODAX IC-knipperrelais
If it is 7 pin relay for SUZUKI, it attaches only by removing a Normal relay and inserting in this relay made from ODAX with a Snap, and is completion.It is thought that the number of blinks increased...
ODAX IC-knipperrelais
The purchase of general-purpose IC relay also has resistance in Turning off the Harness by the portion which does not have a margin in wire length, and purchased here.
The Blinker and a Hazard have n...
? 
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING